Westinghouse Dryer Error Codes

Complete Troubleshooting & Repair Guide

Heating System Errors
E10
Heating Element Fault
  • Check heating element continuity using a multimeter.
  • Inspect wiring connections for burns or looseness.
  • Ensure proper airflow to prevent overheating.
  • Replace heating element if defective.
Sensor Errors
E11
Thermistor Failure
  • Inspect thermistor wiring and connectors.
  • Test resistance at room temperature.
  • Check for moisture or corrosion damage.
  • Replace thermistor if readings are incorrect.
Safety & Overheat Errors
E12
Overheating Detected
  • Clean lint filter and exhaust duct.
  • Check airflow blockage in vent system.
  • Allow unit to cool before restart.
  • Inspect thermal cutoff or fuse.
Motor System Errors
E13
Motor Failure
  • Check motor wiring connections.
  • Inspect belt and drum movement.
  • Test motor resistance and operation.
  • Replace motor if not functioning.
Door System Errors
E14
Door Switch Fault
  • Ensure door closes and latches properly.
  • Inspect door switch alignment.
  • Test switch continuity with multimeter.
  • Replace door switch if faulty.
Control System Errors
E15
Control Board Error
  • Reset power by unplugging for 5–10 minutes.
  • Inspect PCB for burn marks or damage.
  • Check wiring harness connections.
  • Replace control board if issue persists.
Important: If error codes persist after troubleshooting, disconnect power and contact a certified Westinghouse technician.